I'm making a drone, and would love if somebody can review my work on the PCB layout. Image (red is top, blue is bottom, circles indicate holes and side transfers purple is glue): What is supposed to happen: Input from the radios is PWMs 1-6, which is an RF receiver putting in the raw values of the control sticks. The board is supposed to be able to be programmed via the ICE 10 component. The MCU is going to be able to take input from the BMI055 (accelerometer) and GPS and validly parse that. The Li-po inputs are for reading batteries, each wire (besides the first) is a cell. The aux components are of no concern now. PWMs 7-12 are the output, and go to a bunch of ESCs, which control the motors. I feel I'm missing a bunch of passives; the PCB doesn't look like any other I've seen (in the fact that it only has a few resistors and 3 capacitors with advanced components). Component reference: GPS: RXM-GPS-R4 MC1: AC32UC3 U2 and U3: Crystals U1, AUX1, AUX2, all PWMs, U13, and U14: Connectors REG1: LD1117 (3.3V 800mA) ACL1: BMI055 3-axis accelerometer USB: Type B jack ANT1: GPS antenna TANTCAP: 33uF tantalum capacitor
Hi...i am a new user here. As per my knowledge the underside of the module has traces and vias that could short or couple to traces on the product’s circuit board. Make sure there is no top layer PCB copper underneath the module. I would imagine that ground planes on other layers are fine since they are naturally insulated from the top layer. Try not to route any signal/clock lines on any layer directly underneath the module. Keep "noisy circuitry" that doesn't need to connect to it as far away as possible. buried vias pcb